Futura MCB3, Инструкция по установке/Техническая информация

Страница: 48 / 60

M CB 3 Installation Manual Page 46
Technical Setup - Store / Recall
Store / Recall
The control box uses setups that are in "current"
memory to operate.
The control box saves to current memory all setup
values when exiting the Technical Setup Menus.
It also saves to current memory every 30 seconds
while in the operating mode.
The control box has one default memory slot for
storing a factory setup. It also has four memory slots
for saving installer or user customized setups.
The user or installer may copy a setup from current memory to 1 of 4 named memory slots
with the Store function.
The user or installer may copy a stored setup from the 4 named or 1 default memory slot to
the current memory using the Recall function.
The Store / Recall function in the Technical Setup Menu is the same Store / Recall function
in the User Setup.
Store is on the left side. To store a current configuration, rotate the left multi-switch to the
desired number 1 through 4. When selected, press in the multi-switch. A menu will ask if
you would like to store. Select 'Yes' to store. Select 'No' to return to the previous menu.
If Yes is selected, a new name can be entered for the stored setting.
Rotate the multi-switch to scroll and stop on the desired character. Move the multi-switch
to the right to allow selection of the next character. Continue until complete. Up to seven
characters may be used. Once entered, the named setting will appear on the store and
recall side for further use.
Recall is on the right side. To recall a stored configuration, rotate the right multi-switch
to the desired number or name. Press in the right multi-switch. A screen will ask if you
would like to recall. Select 'Yes' to recall and make the stored configuration the current
configuration. Select 'No' to return to the previous menu.
Checksum values are displayed to check copied setups.
5.9
Data Transfer
The Data Transfer function along with the CB Center PC application software allows
presets to be saved from a control box to a PC, and recalled from a PC to a control box via
a serial cable.
Refer to the instructions that come with the CB Center software for further details.
5.10
Store Recall