Futura MCB3, Инструкция по установке/Техническая информация

Страница: 31 / 60

M CB 3 Installation Manual Page 29
Technical Setup - System
System Setup Menu
Slope - Slope Enable
Slope selection is On or Off. When On, the
slope sensors in the receivers, if equipped, are
operational. Slope menu options are available.
When Off, the slope sensors are not operational
and slope menu options are not available.
Rotate the right multi-switch to change the selection.
When On - Calibrate the slope sensor. Ensure
the receiver is properly oriented - the LED display is parallel to the blade.
Ctl%Dsp DB - Control Deadband as a Percentage of Display Deadband
The display deadband is set from the User Setup menu. The default setting is 100%.
Consequently the display deadband and the control deadband are initially the same.
To decrease the control deadband value, decrease the percentage value. For
example, if the display deadband is 0.50 inches and the Ctl%Dsp DB is set to 50%,
the control deadband would be 0.25 in.
Adjust each side of the system. Display is from 0 to 100 in increments of 1%.
NOTE: Smaller control deadband values increase valve movement sensitivity. This
may cause unstable system performance. System performance should be checked
after adjusting. See § 5.6.
Remote Config - Remote Switch Configuration
The remote switch configuration selects the type of remote switch (Multi-switch or
Toggle), how many switches are used, and which side the switch is mounted.
Multi-switches are not the same as Toggle switches. See cable diagrams for part numbers.
Remote switches are installed with the switch facing inward and the cable routed
downward. Once configured, this installation allows thumb activation for forward
movement to Auto and back movement to Manual.
MULT - Multi-switch. All options for the multi-switch are available.
TOGL - Toggle switch. Auto/Manual and Raise/Lower switch options only.
For Dual Multi-switch, set both sides to MULT, and turn on or off the desired remote
functions for each side in the next four menu items.
For Single remote switches, set the side the switch is mounted on to MULT or TOGL,
and turn the other side to NONE. The single remote switch will activate both left
hand and right hand remote functions. Turn Off or On the desired remote functions in
the next four menu items. The Raise/Lower function for the Tilt side is not available.
Single remote switches are wired as left hand remotes and may be configured to
operate the left hand, right hand, or both sides.
5.4
System Setup Menu
Slope
Ctl%Dsp DB
Remote Config
Remote A/M
On