Futura MCB3, Инструкция по установке/Техническая информация

Страница: 42 / 60

M CB 3 Installation Manual Page 40
Slp%Elev Spd - Slope Speed as a Percentage of Elevation Speed
The slope sensors cannot operate as fast
as the elevation sensors of the system.
This adjustment sets the speed of the slope
correction as a percentage of the elevation
correction speed.
This lower speed is only applied to the slope
sensor driven side.
To preset the Slope Speeds, select a slope operating mode from the main menu.
Presetting Slope%Elev Valve Speed - Blade in Air Method:
1. Mount the receiver in its normal operating position to receive the laser.
2. Select an On-grade deadband typically between 0.3% and 1.0% (0.2º and 0.6º) depending
on the jobsite tolerance. Refer to Appendix D for more details.
3. Set the machines throttle to normal operating RPM. Ensure the machine is on flat
ground.
4. Place the blade approximately 1 foot (0.3 m) above the ground.
5. Select Manual control. Tilt the blade to create a coarse (full arrow) lower correction. Select
Automatic control.
7. The blade and receiver will move towards on-grade. Note any overshooting of On-grade.
Repeat procedure for raise correction. Once again, note any overshooting of On-grade. Adjust
the Valve Slope%Elev until there is none or one small overshoot for a coarse correction in
either direction of both sensors.
Increasing Slope%Elev Speed corresponds to a faster, but less stable correction.
Decreasing Slope%Elev Speed corresponds to a slower, but more stable correction.
NOTE: After the Valve Setup is complete, it is recommended to name and save
the settings for future reference. Refer to § 5.8.
Slp%Elev Spd Test
Slp%Elev Spd
<Push> to Return
10
5.5 Valve Setup Menu
Technical Setup - Valve