Futura MCB3, Инструкция по установке/Техническая информация

Страница: 29 / 60

M CB 3 Installation Manual Page 27
Technical Setup - System
System Setup Menu
Highlight System Setup from the Technical Setup Menu and press in the multi-switch.
Toggle the multi-switch up and down to navigate through the System Setup Menu.
Language - Select Language
Turn the right side multi-switch to select
language used in operating modes.
ENG - English
GER - German
FRE - French
ITA - Italian
SPA - Spanish
Technical menus remain in English
Mach Arch - Machine Architecture
Selections are Off, Lift, or Tilt for right side and Lift or Off for left side.
Lift & Tilt is used for a typical dozer configuration. Select Lift on left side for elevation
side receiver; Tilt for the right side.
Lift & Lift is for independently controlled elevation sides, such as a motorgrader.
For single side operation, select Lift for one side and Off on the other side.
Refer to § 3.1 for additional machine architecture information.
X-Couple Enable - Cross Coupling Enable
Cross coupling selection is On or Off. When On,
it communicates corrections from one side to
the other that stabilizes the blade's movement.
If On is selected, the Cross Couple Setup must
be completed.
When On, cross coupling is only applied when
both laser receivers are in the laser beam.
System Setup Menu
< Exit >
Language
Machine Arch
X-Couple Enable
ENG
5.4
System Setup Menu
X-Couple Enable
X-Couple Setup
Slope
Ctl%Dsp DB
On