FUTABA T12Z, Обновление программного обеспечения, Страница: 5 / 16

- 5 -
TM-14 LED indication
When the transmitter is powered up, the LEDs on
the rear of the module will begin to glow or blink
accordingly. The chart below provides you with an
easy reference as to the meaning of the LEDs.
Green Red Status
Solid Solid Initializing
Blink Off RF is off
Alternate Blink Check nearby RF condition
Solid Off RF power on
Solid Blink
RF power on (Power reduced to perform
the range check function)
R6014FS LED Indication
Green Red Status
Off Solid No signal received
Solid Off Signal received, normal operation
Blink Off
Receiver is receiving signals but the ID
is unmatched
Alternate Blink Unrecoverable error (EEPROM, etc.)
Other modifications
Cumulative Model Timer
A cumulative model timer has been added to this
version of the software. To show this timer on the
home screen please follow the instructions below.
The Cumulative Model Timer and System Timer
values are maintained even if they are not displayed
on the home Screen.
1. Open [SYSTEM TIMER] of the System Menu.
2. Select “MODE” and turn the DATA dial and
switch the display to [TOTAL] or [MODEL].
※
The display blinks.
[TOTAL] : Operation is the same as in the past.
[MODEL] : The elapsed time of each model is
recorded.
3. When the DATA button is pressed, the setting is
changed.
Automatic channel assignment
The 12Z will automatically relocate channel
assignments as necessary to achieve the highest
performance. This automatic channel relocation will
occur when you change the modulation type. To
minimize latencies and obtain the highest
performance you should allow the transmitter to
automatically relocate the channels when requested.
Once the channels have been relocated it will be
necessary to verify that the servos are plugged into
the proper channels on the receiver.
1. Change the modulation mode using the
[FREQUENCY] function of the Linkage Menu.
2. A channel relocation confirmation screen is
displayed. To change the channel allocation,
select [YES] and press the DATA button. To
maintain the current channel allocations, select
[NO] and press the DATA button.
Frequency setting
The frequency, modulation and receiver ID can be set
at same time from this version. It is not necessary to
return to the frequency setting screen for each setting.
1. Change the frequency, the modulation mode or
receiver ID using [FREQUENCY] function of the
Linkage Menu.
2. A confirmation screen is displayed.
3. If you want to change other setting, press the
frequency channel button, the modulation type
button or the receiver ID button.
Model type
2 ai 4 flaps and 4 ai 2 flaps have been
added to the glider model types which can be selected
in the PCM1024 mode and the PPM mode.
Motor gliders cannot be handled.