FUTABA T12Z, Обновление программного обеспечения, Страница: 3 / 16

- 3 -
Channel Mode Selection
When using the TM-14 RF module with the T12Z,
there are two modes of operation available:
multi-channel mode (as utilized in conjunction with the
R6014FS receiver) and 7-channel mode (used for
receivers such as the R617FS). It is important to set
the channel mode selection to match the receiver being
utilized in the model. Please refer to the chart below
as a reference guide.
Receiver
Transmitter R606FS
R616FFM
R607FS
R617FS
R608FS
R6014FS
Multi-ch mode
— —
Compatible TM-14
Module
7ch mode Compatible Compatible
—
1. Access the frequency setting [FREQUENCY] in
the linkage menu and then press the DATA
button. The currently selected transmission
mode is displayed.
2. To change the mode selection, select the alternate
transmission mode.
[FASST MULT] : Multi channel mode
[FASST 7CH] : 7 channels mode
3. Press the DATA button, the display will return to
the confirmation screen.
4.
A channel relocation screen will appear. If you
wish to relocate the channel assignments,
select the [Yes]. If not, select [No]. The channel
assignments will not be modified.
(Information pertaining to the 7 channel mode)
When the 7 channel mode is selected, the following
conditions are applicable:
While the setting items of channels 8 and above
may appear in the various menu options (e.g., sub
trims, servo reverse, etc.), the only settings which
are applicable are those of channels 1-7.
When using the 7 channel mode, fail safe is only
available for channel three (throttle). If/when the
fail safe for channel three has been activated, the
battery fail safe is also active. Unlike the multi
channel mode, the fail safe and the battery fail
safe can not be set independently.
Channel Assignment
Servo connection
Below is a reference chart which has been created to
obtain the optimum performance from the FASST
system in conjunction with the channel mode and
various swash types. It is important to note and
adhere to this reference information in order to achieve
the maximum performance from the model. As such,
please connect the servos to the corresponding
channels in the chart below.
Multi channel mode 7 channels mode
CH
Except
H-4, H4X
H-4, H4X
Except
H-4, H4X
H-4, H4X
1 Aileron Aileron Aileron Aileron
2 Elevator Elevator Elevator Elevator
3 Pitch Pitch Throttle
Throttle
4 Rudder Elevator2 Pitch Pitch
5 Gyro Rudder Gyro Gyro
6 Throttle Throttle Rudder Rudder
7 Governor Gyro Governor
Elevator2
8 Governor Governor AUX5 AUX5
9 Needle Governor AUX4 AUX4
10 AUX3 Needle AUX3 AUX3
11 AUX2 AUX2 AUX2 AUX2
12 AUX1 AUX1 AUX1 AUX1
VC1 AUX1 AUX1 AUX1 AUX1
VC2 AUX1 AUX1 AUX1 AUX1
VC3 AUX1 AUX1 AUX1 AUX1
VC4 AUX1 AUX1 AUX1 AUX1
It is important to note that these settings differ
from that used in the previous G3 receivers.
Utilizing the channel assignments from the G3
receivers will not allow you to obtain the ideal
performance from your model.
Please note that the settings in the chart above
are the default settings. As such, when the
data is reset, the channel assignments above
will be utilized.