Fusion FBUL NP12-12, Инструкция по установке и наладке

Страница: 64 / 88

Fusion Installation & Commissioning Manual Approved document No UI-FBU-01 issue 3.0
64
MENU AND CONTROL FUNCTIONS continued
Key to menu.
1. View active faults.
This option provides a method of viewing faults on the system when there are active fire
events present.
2.
View active disablements.
This option allows the user to identify parts of the system that have been isolated.
3. View event logs.
This option allows the Alarm log and the Event log to be inspected.
4. Test lamps
5.
Clear event logs
6.
Set disablements.
This option allows remote outputs, sounders, loop and zones to be disabled and also enabled
manually or automatically at a preset time and date.

Remote Contacts can be disabled or enabled for test purposes. This applies to relay 1, relay 2,
common fault or the loop module relays.

Sounders can be disabled if required and enabled again.

The Loop can be isolated on this option.

Any selected zone can be disabled or enabled.

Any of up to 126 devices on the loop can be disabled or enabled.

Timers can be set for devices or outputs, to be re-enabled automatically at a specified time
and date with this option.

Programmed delays can be disabled .

All disablements, on whatever device or line, can be cleared simultaneously

A programmable option is available to use a switch monitor or input module to isolate pre-
determined groups of devices. This is set up via the cause and effects parameters.
7.
Set clock.
Allows the time and date to be entered via the keypad.
8. Activate test mode.
Allows zones to be tested individually or all together. With or without sounder. An optional
managers code can be used to allow access to this function.
9. Print options (if printer is fitted)
10. Set delays / dependencies (if programmed)
Switches delays / dependencies ‘off’ or ‘on’
11. View Groups
Status of cause and effect groups can be viewed.
12. Enter access level 3 (Engineering options)
In order to access the Engineering options a security code is needed which is normally
restricted to engineering personnel only. The code is 1950+