Furukawa electric S153 Ver.2, Руководство пользователя

Страница: 111 / 164

Programming Guide
8-33
8.4.1. Machine Check
1. A pop-up message prompts the user to remove the fiber
from the machine. Follow the message and press OK key.
2. Select “Execute” in the pop-up screen and press Enter
key to initiate the Machine Check. Or, select “cancel” to
cancel the operation.
3. S153 Ver.2 automatically checks for dust in the camera
and verify the motor movements (see sample screen to
the right). Then, a pop-up screen prompts the user to set
the fiber in place.
4. Set the fibers on both sides and press to initiate the remaining check.
5. S153 Ver.2 automatically performs the remaining check and a pop-up message prompts the
user to perform an arc check.
6. Press Enter key and select “Execute” or “Cancel” to perform the arc check. In the pop-up
screen, press Enter key again.
7. After the machine check is complete, the pop-up screen shows “Status OK”. Press Escape
key to finish the check.
8. If the machine fails Machine Check, the pop-up screen shows “Status NG. Call the Service
Center”. Please call your representatives or Furukawa Electric for further assistance.
9. If arc check fails, pop-up screen shows “Status NG. Remove fibers, and retry Arc Check”.
Perform an arc check to optimize the arc power.