Furukawa electric S124, Руководство пользователя

Страница: 8 / 109

7
WARNING
STOP using the fusion splicer when problems are experienced with
the protection sleeve heater. Turn off the power immediately,
disconnect the power cord, remove the battery, and contact your
local service center.
Do not use a gas spray to the splicer. The hazardous gas may come
out by electric discharge. It may cause a fire and machine failure.
The S124 complies with the following tests:
Drop resistance – 76cm drop from 5 different angles.
Water resistance – IPX2 rating drip proof (exposed to 3mm/min
drip for 10 min with 15° tilt).
Dust resistance – IP5X rating dust proof (exposed to dust
particles with a diameter of 0.1 to 25µm for 8 hours)
External Impact resistance – IK07 rating external impact proof
(exposed to 500g weight dropping from 40cm height)
Above tests were performed at Furukawa Electric laboratories and
do not guarantee that the machine will not be damaged when
subjected to these conditions.
CAUTION
Do not place the fusion splicer on an unstable or inclined surface.
There is a possibility that the fusion splicer could fall and cause
injury.
Disconnect all cords when moving the fusion splicer. Failure to do
so may damage the cords and result in fire or electric shock.
Do not place the cords around any heating instrument. Doing so
may damage the cords and result in fire or electric shock.