81
Error Message
Cause of Error
Action
FEEDING ERROR
(The motor does not
stop after the time
limit from the start.)
Defect in the motor
driving system.
Contact service center.
OVER-RUN
(The motor detected
the overrun limit
when running
forward.)
Fiber is not loaded or not
in the proper position.
Load the fiber at the
proper position.
Inappropriate fiber
program is selected.
Check and correct the
program.
Bad cleaving quality.
Defect in the image
processing system.
Contact service center.
Defect in the motor
driving system.
Contact service center.
V-groove is dirty.
Clean the V-groove.
HEAT TIME OUT
(The temperature
does not reach the
set value within the
time limit from
heating start up.)
Incorrect parameter is
set for heating.
Check and correct the
parameters.
Defect in the heating
system.
Contact service center.
Heater Error No.13 Incorrect parameter is
set for heating.
Check and correct the
heating parameters.
Heater Error No.17 Incorrect parameter is
set for heating.
Check and correct the
heating parameters.
Voltage decrease
Recharge the battery.
Use the AC adaptor
Heater Error No.18 Incorrect parameter is
set for heating.
Check and correct the
heating parameters.
Heater Error No.23
Incorrect parameter is
set for heating.
Check and correct the
heating parameters.