61
8.4.1 Machine Check
1.
A pop-up message prompts the user to
remove the fiber from the machine. Follow
the message and press OK.
2.
NJ001 automatically checks for dust in the
camera and verifies the motor movements
(see sample screen to the right).
Pop-up screen then prompts the user to set the fiber in place.
3.
Set the fibers on both sides and press to initiate the remaining
check.
4.
NJ001 automatically performs the remaining check and a pop-up
message prompts the user to perform an arc check.
5.
Press Enter and select “Execute” or “Cancel” to perform the arc check.
In the pop-up screen, press Enter again.
6.
After the machine check is complete, the pop-up screen shows “Status
OK”. Press Escape key to finish the check.
7.
If the machine fails the machine check, a pop-up screen shows “Status
NG. Call the Service Center”. Please call your representatives or
Furukawa Electric for further assistance.
8.
If the arc check fails, pop-up screen shows “Status NG. Remove fibers,
and retry Arc Check”. Perform an arc check to optimize the arc power.
When execute "Machine Check” function, please use fibers on
which stripping, cleaning and cleaving were performed right.
When the result is “Status NG “, please refer to “Maintenance”
about disposal.