FULTON VSRT Series, Инструкция по установке, эксплуатации и обслуживанию, Страница: 70 / 118

© Fulton Group N.A., Inc. 2022
3-6
OPERATION
VSRT-IOM-2022-0728
SECTION 3
Guide when performing an y changes on the unit flame programmer.
1. Press and hold the F and A buttons simultaneously. You will be prompted
for your password (####).
NOTE:
–
#### is the last four digits of the national board number.
2. Enter your password and press the “Enter” button.
3. Using the “–” button, scroll to parameter level 100.
4. To enter into a parameter level and start programming, press the enter
button.
5. Use the “+” and “-” buttons to scroll through the parameters.
6. Press the enter button to enter the parameter. The current value will start
flashing.
7. Use the “–” button to decrease the value or “+” button to increase the value.
8. Once the desired value has been set, press the “Enter” button. The number
will stop flashing.
9. Press the “–” and “+” buttons together to back out of the parameter level
when finished.
10. Press the “–” or “+” buttons to scroll to the next section of the program.
11. Repeat this process until all parameters have been reviewed and set.
12. Once the parameters have been programmed, back out to the front screen
by pressing the – and + buttons together.
!
WARNING
This information is for reference purposes
only. Fulton Companies is not responsible
for this product, including (but not limited
to) its accuracy, reliability, and safety. No
Fulton document should substitute for full
review of documentation available from
the product manufacturer.