Precautions about Medical Telemeter
D A N G E R
When monitoring a patient using wireless telemetry, make sure the patient
data is properly received at the central monitor. Pay special attention when
the channel ID at the bedside monitor is changed.
W A R N I N G
z
Depending on the wireless combinations, interference may generate
with other telemeters.
z
Before selecting a channel, verify it will not interfere with other
channels.
z
Make sure the telemetry manager of your system is aware of any
changes to the telemetry channels.
z
If transmitters are used in a neighboring medical facility, your facility
and neighboring facility must make agreements on the setting of
telemetry channels to prevent telemetry interference.
C A U T I O N
z
Precautions about the Installation
y
The medical institution (hereinafter referred as “Institution”) must
decide the telemetry installation plan for the medical institution in
order to prevent interference and interference between transmitters
(telemetry based on destination country’s radio law). When telemetry
has already been installed and been used, radio format, frequency,
and antenna power are required to be examined to prevent
interference.
y
When using telemetry which requires zone location, the Institution is
to set up the zones as an operation unit for each transmitter to
prevent electronic interference between telemetry throughout the
medical institution.
y
When using telemetry which requires zone location, display and
identify each prepared zone in the equipment.
y
When laying receiver antenna for each transmitter, the Institution has
to examine the installation so that electronic interference does not
occur.
y
Based on the above examination result, the Institution should place
each receiver antenna as required.
C A U T I O N
z
Precautions about the Management
y
The institution appoints a person to manage the wireless channels for
the whole medical institution. And when using telemetry which
requires zone location, the Institution should nominate a person to
manage the wireless channels in each zone (a “Zone Manager”).
However, when using such telemetry in a local medical institution,
one person can perform both functions.
y
Select a telemetry manager who understands the characteristics and
functionality of telemetry systems, and is skilled in operating
telemetry.
y
When installing telemetry, the Overall Manager and the Zone
Manager have to understand the precautions for use of the telemetry
in advance.
y
The Overall Manager takes responsibility of wireless channel
management and transmitter storage for the whole Institution by
giving proper instruction.
viii
Содержание DSL-8001
