1 Installing the Unit to a Server
51
E
4
Select the [Hardware] tab and click [Device Manager].
5
Double click [Other devices], and then double click [TANDBERG
TS400 SCSI Sequential Device].
6
Select the [Driver] tab and click [Update Driver].
The "Welcome to the Device Driver Upgrade Wizard" message appears.
7
Click [Next].
8
Select [Find the best driver for the device], and click [Next].
9
Select [Specify the location], click [Next], set the folder which
restored the driver in the copy source, and click [OK].
• Example: When using the supplied driver floppy (or when the downloaded driver was
restored in a floppy)
A:\lto2\i386
• Example: When using a CD such as ServerStart (When CD-ROM is E drive)
[CD-ROM drive]:\DRIVERS\tape\lto2\i386
The "The following device driver is found" message appears.
10
Click [Next].
The "Completing the Device Driver Upgrade Wizard" message appears.
11
Click [Complete], and click [Close].
12
Restart the server.
1.4.2 Driver Installation (For PRIMERGY FT)
Notes
• This product can be installed only to FT1. It cannot be installed to FT2.
• Two of this product cannot be installed at the same time.
• This product cannot be used from CoServer.
• FT model cannot restore the system using Automated System Recovery (ASR) set or system
recovery disk. For restoration, use the recovery CD supplied with the server.
• For installation of the internal 5-inch option, refer to the User’s Guide of the FT model.
For Windows Server 2003
1
Install this product to FT1.
2
Turn on the power of FT1 and FT2, and start the CoServer in online
mode.
3
Log on to the CoServer1 with administrator privileges.
