Appendix C Setting Procedures for Replacing HBAs
C.2 Overview of the Procedure
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED
P2X0-1260-19ENZ0
416
C.2
Overview of the Procedure
The workflow for replacing an HBA is as follows. Perform the following procedure.
(1) Check the connection status between the host and the ETERNUS DX/AF.
Refer to
"C.3 Checking the Connection Status Between the Host and the ETERNUS DX/AF" (page 417)
for
details.
(2) Replaces the HBA in the host and connects the host and the ETERNUS DX/AF.
This operation must be performed by a maintenance engineer.
(3) Perform the system settings according to the connection status that was checked in Step (1).
-
When the host affinity settings are used
Settings for the ETERNUS DX/AF are required. Refer to
"C.4 Required Storage System Settings After HBA
Replacement (When Host Affinity Settings are Used)" (page 418)
for details.
-
When the host affinity settings are not used (conventional LUN mapping is used)
Settings for the ETERNUS DX/AF are not required. This ends the replacement procedure for an HBA.
The following procedure is an example when a FC interface is used between the host and the ETERNUS DX/AF.
The same procedure can basically be used even when the interface type is iSCSI or FCoE.
Содержание ETERNUS AF250
Страница 2: ...This page is intentionally left blank ...
Страница 423: ......