Fujitsu 770Tx, Руководство пользователя

Страница: 129 / 201

U s e r I n s t a l l a b l e F e a t u r e s
L i f e B o o k 7 0 0 S e r i e s f r o m F u j i t s u
119
4. When the notebook goes into the Suspend
mode you can safely remove the device from
the Multifunction Bay.
5. Slide the release latch at the left rear corner of
the Multi-function Bay toward the outer edge
of your notebook.
6. Slide the device forward until the unit is clear
of the compartment. This will require some
force. Use the finger ridge on the bottom of
the device.
Multi-function Bay 2
Release Button
Figure 4-3 Removing and Installing a
Device in Multi-function Bay 2
4.Orient the item to be installed with the finger
ridge away from the body of your notebook
and the connector toward the body of
your notebook.
C A U T I O N
The system must be in Suspend mode
before attempting to insert a device into
either of the Multi-function Bays. Failure
to do so can cause damage to your
notebook or the device.
Installing a Device in Multi-function Bay 2
1. If you are swapping a device your computer
should already be suspended. If it is not, go
through steps 1 to 4 of the previous section
(Removing a Device in Multi-function
Bay 1 or 2) to place your notebook in
Suspend mode.
5. With the module connector toward the back
of your notebook align the grooves on the
side of the device with the tracks in the side
of the bay. (Figure 4-3.)
6. Slide the module toward the back of your
notebook until it clicks into place.
7. Press the Suspend/Resume Button to reacti-
vate the notebook from the Suspend mode.
8. The Tioman software will automatically
detect the new device and place it online.