A26361-K879-Z102-3-7619
61
Preparation for use and operation
Switching the Server ON/OFF
5.3
Switching the Server ON/OFF
V
CAUTION!
If after switching ON the server there is nothing but flickering stripes on
the screen, switch the server OFF immediately (see chapter “Problem
Solutions and Tips” on page 67).
The ON/OFF button does not disconnect the server from the mains
voltage. To completely disconnect it from the mains voltage, remove the
power plug from the socket.
Switching the server ON
The power-on indicator (position 2 on figure 27 on page 55) lights orange
(standby mode).
–
First system installation:
Ê
Press the ON/OFF button (position 1 in figure 27 on page 55).
Ê
Insert the
ServerStart
-CD and/or an installation disk in the corresponding
drive.
Ê
Follow the instructions on the monitor (see also section “Configuration
with ServerStart” on page 62 and/or section “Configuration without
ServerStart” on page 63).
–
System already installed:
Ê
Press the ON/OFF button (position 1 in figure 27 on page 55).
The server is switched ON, performs a system test and boots the
operating system.
Switching the server OFF
Power-on indicator (position 2 on figure 27 on page 55) lights green.
Ê
Shut down the operating in an orderly manner.
Ê
Press the ON/OFF button (position 1 in figure 27 on page 55) and/or send a
corresponding controlling signal (see Other ON/OFF possibilities).
The server switches OFF and goes in standby mode.
