Fujikura FSM-40S, Руководство по обслуживанию

Страница: 25 / 67

Page 25
§ 4.2. Installing Z-Unit
1. Refer to Fig. 4.2.1 for steps 2~3.
2. Loosely Attached Z-Motor Unit to Base Frame with Cap screw M3×10
3. Apply pressure by pushing Z-Motor forward. Tighten Cap screw (M3×10, T=10, WS3, SLG).
Fig. 4.2.1
4. Refer to Fig. 4.2.2. Place Liner (t=0.7) between Z-Unit and Frame-Base. Note – A small amount of
Silicon-Grease may be applied to Liners to help maintain their position during installation.
5. Refer to Fig. 4.2.3. Apply pressure by Pushing Z-unit against Frame-Base center and back.
6. Tighten Cap screw (M3×10, T=10, WS3).
Liner(t=0.7)
(S1330M-04-18)
Cap screw M3×10
(T=10,WS3)
Pushing
Fig. 4.2.2 Fig. 4.2.3
Pushing