FujiFilm DR-ID 670, Руководство по эксплуатации

Страница: 52 / 62

O-4
Appendix O Use of Optional Items
DR-ID 670 Operation Manual 897N102735
O.4 Cradle
Cradle
(DR-ID 601SE/DR-ID 602SE/DR-ID 611SE/DR-ID 612SE)
Cradle for 24
(DR-ID 613SE)
CAUTIONS
● Handle the Cradle carefully. Do not hit or drop the Cradle or subject it to severe shock to avoid
possible damage.
● If any damage such as cracking, chipping or peeling is found on the Cradle, use it after repair.
Otherwise, personal injury may result. Consult a FUJIFILM dealer for repair.
● If excessive force is applied to the Cradle, it may be damaged. Also, do not apply excessive force to
the fl at panel sensor inserted in the Cradle.
● When carrying the Cradle, if you accidentally drop it, your foot may be injured.
● Do not make an exposure when the fl at panel sensor is inserted in the Cradle.
● Do not pull the cable forcibly. Otherwise, the cable may be broken or the Cradle may be damaged.
1
Remove the SE cable or the cover from the
fl at panel sensor.
Connector
For connection and disconnection of the SE cable
of the fl at panel sensor, see "3.1.3 Connecting/
Disconnecting the Flat Panel Sensor Connector".
2
Insert the fl at panel sensor.
Confi rm the position of the connector, align the fl at
panel sensor with the Cradle, and then slowly insert
the sensor straight all the way along the guides at
both sides.
Flat panel sensor Connector
Alignment mark
Connector
Alignment mark
Guide
Guide
3
Check the status lamps of the fl at panel
sensor (when the SE cable is connected).
Make sure that the ERROR (Orange) status lamp
changes as follows after inserting the fl at panel
sensor into the Cradle.
Before insertion After insertion
Wireless
communication
possible
Not lit
Turns off after
turning on
for about 1.0
second or below
Wireless
communication
not possible
Lit Turns off
If the ERROR status lamp changes as above,
communication between the fl at panel sensor and
the power supply unit is established normally.
ERROR (Orange)
4
Remove the fl at panel sensor.
When performing an exposure, remove the fl at panel
sensor from the cradle.