FujiFilm DR-ID 670, Руководство по эксплуатации

Страница: 33 / 62

3-1
Basic Operation
3
DR-ID 670 Operation Manual 897N102735
Chapter 3
Basic Operation
3.1 Preparing the Flat Panel Sensor
This section describes how to prepare the flat panel sensor.
3.1.1 Type of Flat Panel Sensor
DR-ID 601SE, DR-ID 602SE, DR-ID 611SE, DR-ID 612SE and DR-ID 613SE :
Wireless communication mode or wired communication mode is available. When used in wireless
communication mode, an access point*
1
, battery pack (optional) and battery charger (optional) are
required.
*1 In the countries other than the U.S., an access point is not included as a component of the system. For
details including installation, consult our official dealer.
• Product compliant with IEC60950, UL60950, PSE or JIS
• Compliant with IEEE802.11n [W52] (in the 5.2GHz band) /36, 40, 44, 48ch
• WLAN interface: 1000BASE-T/100BASE-TX (minimum requirements)
• LAN interface: 1000BASE-T/100BASE-TX (minimum requirements)
• Available OS: Linux
• Compliant with UL
• Compliant with FCC part15
CAUTIONS
Use only one access point. A communication error may occur if two units or more are used.
3.1.2 Number of the Connectable Flat Panel Sensors
To enable the flat panel sensor, its ID needs to be registered in advance by a FUJIFILM dealer.
Up to five flat panel sensors can be registered.
Up to three flat panel sensors*
2
can be connected to the power supply unit at the same time.
*2 When three flat panel sensors are simultaneously used with the power supply unit and in wired
communication mode, two power supply units are required.
(Connection example)
Flat panel sensor
Flat panel sensor
Power supply unit
(DR-ID 600MP)
Access point
Flat panel sensor
Wired communication mode
Wireless communication mode
When multiple flat panel sensors are connected, make sure that the READY lamp among the status lamps of the
flat panel sensor to be used for an exposure is lit.