FujiFilm CR-IR 355RU, Руководство по эксплуатации

Страница: 59 / 126

A-3
Specifications
A
FCR XC-1 Operation Manual
First Edtion 11.2005 897N0565
A.1.2 Operating Performance
(1) Processing capacity
IP size
Processing type
14
"
×17
"
14
"
×14
"
10
"
×12
"
8
"
×10
"
24×30cm 18×24cm
Throughput
(Unit : Min. number of
processable IPs/hr.)
35 40 45 56 45 60
Feed/load time
(Unit : Max. time in
seconds)
101 88 80 64 79 60
• If the maximum dose applied on the IP exceeds 40mR (1 [mR] ≈ 8.7 [µGy]), the cycle time increases as the X-ray
dose increases.
• The time required for changing the cassette is assumed 0 seconds.
• The erasure time is based on 25mR of X-ray dose (1 [mR]
≈ 8.7 [µGy]) applied at exposures.
• The ST-VI type IP is used (the erasure time is extended for the ST-VN type IP).
(2) Time required for monitor image display
Time required for an image to be displayed on the monitor after the cassette has been inserted.
(Unit : Max. time in seconds)
Time required for
monitor image
display
(for each image
reading size)
Monitor
14 " ×17 " 14 " ×14 " 10 " ×12 " 8 " ×10 " 24×30cm 18×24cm
CR Console 52 46 41 33 41 31
(3) Time required for generating film prints
(Unit : Max. time in seconds)
Printer
(printout on a
14 " ×17 " film)
Console
DRYPIX 7000 DRYPIX 4000
14"×17" IP 14"×14" IP 14"×17" IP 14"×14" IP
CR Console 135 130 155 145
* For one-image printout.
(4) Required specifications and other
Basic requirement for the CR
Noise (DQE) : Should be within the range specified below.
Between 19.8% and 11.6% at 1cy/mm (258nC/kg of X-rays)
* The guaranteed initial center value is 17.0% for the six years of the equipment’s
effective life time.
Sharpness (MTF) : Should be within the range specified below.
Between 66.2% and 54.2% at 1cy/mm (825.6nC/kg of X-rays)
* The guaranteed initial center value is 60.0% for the six years of the equipment’s
effective life time.
Artifact : Should be free of image unevenness that may affect the diagnosis.