Fuji Electric Monitouch S8 series, Руководство по подключению

Страница: 280 / 406

17.1 Temperature Controller/Servo/Inverter Connection 17-3
17.1.2 DMC10
Communication Setting
Editor
Communication setting
(Underlined setting: default)
Controller
Rotary switch for device address
CPL communication setting
Make the following settings on the PC loader. (Underlined setting: default)
Available Memory
The available memory setting range varies depending on the controller model. Be sure to set within the range available for
the controller. Use [TYPE] when assigning the indirect memory for macro programs.
* Addresses 5000 to 8999 are allocated for EEPROM data addresses.
The number of times EEPROM can be reprogrammed is limited (approx. 100000 times). As such, we recommend that
you write such a parameter as to be reprogrammed frequently into RAM, where the number of reprogramming times is
not limited. However, when the parameter has been written into RAM, and the power is turned off and back on, data in
EEPROM is transferred.
For more information, refer to the instruction manual for the controller issued by the manufacturer.
Item Setting Remarks
Connection Mode 1 : 1 / 1 : n / Multi-link2
Signal Level RS-232C / RS-422/485
Baud Rate 4800 / 9600 / 19200 bps
Data Length 7 / 8 bits
Stop Bit 1 / 2 bits
Parity None / Odd / Even
Target Port No. 1 to 31
MODULE ADDRESS Setting Remarks
1 to F Communication is disabled when “0” is set.
Setting Items Setting Remarks
CPL/MODBUS 0: CPL See “20. MODBUS”.
Baud rate
1: 4800 bps
2: 9600 bps
3: 19200 bps
Data type
0: 8 bits / 1 bit / even
1: 8 bits / 2 bits / none
4
3
2
1
0
F
E
D
C
B
A
9
8
7
6
5
Memory TYPE Remarks
--- 00H