Fronius Robacta TSS /i, Руководство по эксплуатации, Страница: 69 / 100

General information
Wire cutter The wire cutter can be used to cut two wire electrodes with a diameter of up to 1.6 mm
(0.063 in.)
The opening and closing of the wire cutter is triggered by an active signal from the robot
controls.
TC 2000 dipping
bowl The use of the dipping bowl is recommended in the case of:
-
gas-cooled welding torches
- water-cooled welding torches in the higher power range (hot gas nozzles)
Advantages:
-
The spatter accumulation on the gas nozzle loosens.
- The welding torch is also cooled.
- The anti-stick agent contained in the parting agent prevents new contaminations.
max. 75 mm
(2.95 in.)
(1)
NOTE!
Immerse welding torch a maximum of
75 mm (2.95 in.) into the dipping bowl.
▶
The gas holes (1) must remain dry.
Robacta TC 2000 Robacta TC 2000 is an electromagnetic cleaning unit for welding torch cleaning in steel
applications.
After 50 seconds of charging time, the maximum magnetic flux density is available for
the cleaning process.
The cleaning process (discharge process) is initiated by the “Cleaning start” signal.
Specification of
the Parting Agent
Volume In the case of high-pressure gas purging with parting agent, the parting agent volume is
specified via the duration of the external “Pump for parting agent” signal.
The longer the signal is present, the more parting agent is injected.
Cleaning End
without Touch
Sense Option If the Touch Sense option is not installed on the service station, then the cleaning pro-
cess is ended at the wire cutter.
69
EN-US