Frigomat TAYLOR IC135 Series, Инструкция по эксплуатации и техническому обслуживанию

Страница: 28 / 71

27 - ENGLISH
5.6.4 PRODUCTION OF WATER ICE WITH TIME CONTROL (GR2)
The programming of this cycle is based on the
control of production times and on cyclical mixing.
- Press the “ STOP ” and “ SEMIAUTOMATIC ”
buttons simultaneously and the display, which
shows
GR1 , the “water ice” led and the “ UP ( ▲ )”
– “ CONFIRM ( ◄► )” – “ DOWN ( ▼ )” buttons light
up. At this point the machine si ready for the
selection of the desired water ice program.
- Press “ UP ( ▲ )” or “ DOWN ( ▼ )” to select the
GR2 cycle.
- Press “ CONFIRM ( ◄► )” to confirm the selection
of program GR2 .
- The display shows the last consistency value set.
Press “
UP ( ▲ )” and “ DOWN ( ▼ )” to respectively
increase and decrease the water ice production
time (limits from 1’ to 10’). After fixing this value
press “
CONFIRM ( ◄► )” to save the settings and
start the cycle. The recommended value ranges
from 3’ and 7’.
- During the production cycle the compressor will
always run, whereas the mixer will stop for 10”
and run for 1”. At the end of the set time the
“
WATER ICE ” button flashes and an intermittent
beep goes off.
- Press “ MIXING ” and extract the product.
The GR2 program does not foresee the
automatic preservation of the product at the end
of the cycle.