Frigidaire FFH17F8HW0, Обслуживание

Страница: 40 / 54

Section 5 Component Teardown
5-4
Figure 5-8. Control Removal
Door Lock Removal
The door lock assembly is secured to the door
assembly with a locking fork located inside the outer
door panel. The inner panel must be removed first to
access the lock assembly.
To remove the lock assembly (See Figure 5-7):
1. Carefully remove enough foam from inside outer
door panel to gain access to the locking fork.
2. Use a flat-bladed screwdriver to push up on the lock-
ing fork until it disengages the lock mechanism.
3. Pull lock assembly out of door liner.
4. When re-installing, replace foam around locking fork.
EZ Set Control Assembly Removal
The EZ Set control assembly is mounted inside the front
of the door assembly and is secured in position with
retaining latches. The electronic board is secured to the
inside of the bezel with retaining latches.
To remove the EZ Set control assembly:
1. Using a small flat bladed screwdriver, carefully pry
under the bezel until the retaining latches release
from the door assembly. Pull control assembly
straight out to avoid damaging the electrical
connection wire prongs. (See Figure 5-8)
Door Shelf Guard Removal
The door shelf guard is secured to the inner door panel
with two tabs on each end.
To remove the door shelf guard, bend the door shelf
guard out in the middle while bending out the outer
portion of the inner panel outwards, then pull the tabs of
the door shelf guard out of the inner panel.
(See Figure 5-9)
Figure 5-7. Door Lock Removal
Retaining
Latches
Bezel
Figure 5-9. Door Shelf Guard Removal
Door Shelf Guard
Bend Here
Bend Out
Here