Item
Action
12. Throttle
ADVANCE directly to hover
Prior to start, check the surrounding area to ensure people and objects are clear of ALTA Pro
and its props. Also ensure that there are no people or objects between the ALTA Pro’s
takeoff location and its intended flight path.
Ensure that ALTA Pro QGroundControl shows all sensors are calibrated and ready for flight.
ALTA Pro’s props spin at a high RPM and the ends of the blades move at high
speeds. ALTA Pro’s props can cause severe injury or death or cause damage to
objects while rotating. Always ensure the area surrounding the props and
ALTA Pro is clear of people or objects prior to starting the motors.
Do not approach ALTA Pro while it is armed or motors are spinning.
To start the motors, hold full low throttle and full right yaw. Ensure that all the motors are
spinning. Raise RPMs slightly and move the pitch, roll, and yaw controls slightly. ALTA Pro
should pitch, roll, and yaw as commanded due to isolator cartridge flex. Ensure that the
ALTA Pro behaves as expected. If it does not, shut down ALTA Pro and ensure the propellers
are installed in the correct orientation and radio settings are correct.
Do not make large yaw commands while on the ground with the inverted
landing gear installed. Large yaw commands can cause instability.
After checking flight control directions, advance the throttle directly from idle to hover
throttle. Prior to takeoff, do not advance throttle stick above idle until prepared for flight as
this can spool up motors undesirably. While throttling up for takeoff, do not loiter in ground
effect. Once in flight, use the Mode Switch to select between Manual, Altitude, or Position
Mode only after first confirming proper flight performance in Manual Mode.
Содержание Alta 8 Pro
