FPM Agromehanika 408 D, Установка/Обращение/Обслуживание

Страница: 28 / 66

NOTE: YOU CANNOT CHANGE THE TRANSMISSION DEGREE DURING DRIVING. CHANGING
TRANSMISSION DEGREE IS ONLY POSSIBLE WHEN THE MACHINE IS NOT MOVING.
ENGINE STOPPING
- Set the gas command to a minimum.
- Allow the engine to run for about 5 minutes (to cool the engine) and thus prevent the injection
nozzle from burning.
- The gear knob is set to neutral position - position "0".
- Release the safety lever - the engine stops.
ENGINE DEVELOPMENT
The lifetime and working safety of the engine depend to a large extent on engine development. During
the first 50 hours of operation, the engine should be loaded with about 50%, which means that the lever
for regulating the speed must be opened only up to half of its course. The cold engine should run for 10
minutes, and for the next 5 minutes without load with a half-open lever to regulate the speed. After 50 -
100 working hours you can increase the load to about 3/4 of the full available power of the machine.
CARE AND MAINTENANCE OF THE MOTOCULTIVATOR
You bought a reliable machine, but only if you properly nourish it and conserve it, can you expect a good
performance and a long service life.
This chapter provides all the necessary information that the operator of the motorcycle needs to know
and adhere to, as well as explanations for performing the most basic settings for which the need may be
indicated during work.
MAINTENANCE OF THE BASIC MACHINE
a) - Before each use of the motocultivator, check the oil level in the gearbox housing. Check is made on
the control plug located on the right side of the gearbox housing.
b) - Regularly change the oil in the gearbox housing, and keeps the oil drain plug and oil pan and its
environment clean, so that dust and dirt do not get into the interior.
- The first oil change takes place after 25 working hours
- The following replacements are made after every 100 hours of operation. For this you need 2 liters of
SAE 80 lubricating oil, for example. UMOL 80 REFINERY "INA" or TRAKTOL 80 refinery "MODRI
Č
A"
- Replace the oil only when the machine is heated to working temperature.
c) - Keep the parts that are important for the functioning of the machine and keep them clean as well as
the entire machine.
- regularly check the tightening of the bolts and nuts, and, if necessary, tighten them with the necessary
tightening torque.
d) - Regularly lubricate all moving parts with oil, or technical lubricant, such as the cables of the
individual controls (pour a little oil into the shroud of the cable control).
e) Check the air pressure in the drive wheels tires, which should be 2.25 bar. Make sure that both tires
have equal air pressure, allowing easier driving or control.
f) - The braking device, both for driving and for parking, should be controlled in terms of proper
functioning.
- The brake system should be adjusted regularly, even if it is currently operating.
- At least every 6 months, you need to decompress and clean the braking device. This is best done by
an expert of the IMT Boljevac service.
STORAGE OF THE MOTOCULTIVATOR
PREPARATION FOR STORAGE: