FPM Agromehanika 408 D, Установка/Обращение/Обслуживание

Страница: 24 / 66

-
sharply pull the rope to start in the direction of
the arrow displayed on the belt
-
If the engine does not start immediately, try
again
-
When the engine starts, leave it to work for
about 5 minutes at a lower speed to ensure the
necessary lubrication
-
the motocultivator is ready to work
Picture 21
- STARTING THE ENGINE AT LOWER EXTERNAL TEMPERATURES -
Once again, you should know that in cold weather, and with the use of too much viscous oils, it is
very difficult to start the engine. Therefore, remember:
- For outdoor temperatures below 0ºC, you should use SAE 10W viscosity oil.
To start the engine at low outside temperatures, you can use the following as your own choice:
Picture 22
a) - remove the rubber stopper (see Pic. 22 pos. A)
and fill in 2 - 3 cm3 of the lubricating oil SAE 10 W,
or a mixture of lubricating oil and fuel in the ratio 1:
1 in the openings.
- return the plug again to its place.
- NOW start the engine.
Picture 23
b) - To facilitate the start of the engine, you can
use the "start spray" supplied in pressure
bottles.
If you use it properly, and in accordance
with the instructions given on the bottle itself,
the contents of one bottle can be 80 to 100
start-up of the engine.
Immediately before or during startup, this
liquid should be dispersed for 1-2 seconds
directly to the suction port or air purifier (see
Pic. 23).
- STARTING THE HEATED ENGINE -
To start a hot (heated) engine, proceed as stated in the "starting the cold engine" section
without the need to pull the extra charge control.
STARTING THE ENGINE WITH FPM 414DE ELECTRIC MOTOR
- STARTING THE COLD ENGINE
A
B