Foxpro FURY 2, Инструкция по эксплуатации

Страница: 9 / 36

9 | P a g e
the charge cycle. If the temperature edges towards a dangerous level, the
charge current will be interrupted and the green LED will extinguish. If
excessive temperature is not detected, the green LED will not be extinguished.
It is quite possible for the batteries to be fully charged without their temperature
rising to the dangerous level. For this reason,
the LED should not be
considered as a “full charge” indicator as it may or may not extinguish when
the batteries are fully charged. The batteries are fully charged any time their
temperature rises substantially above ambient. How long this takes depends
on how much charge has been taken from the batteries and how much time
has passed since the last charge. If the green LED goes out, the batteries are
definitely charged. If the green LED is on and the batteries are cool, they are
still charging. If the green LED is on and the batteries are very warm, they are
fully charged and you should terminate the charge by unplugging the charger.
You should not permit the charge to continue for more than 10 hours
under any circumstances
. The batteries need to be recharged when the “Low
Battery” LED is blinking. Battery run time is directly related to how loud you
operate the FURY 2. Using both speakers at the same time rather than only the
most appropriate one will have a negative impact on run time. With one
speaker playing, expect 6 to 15 hours of run time, depending on the loudness
setting. With both speakers playing, expect 3 to 10 hours. Remember that very
loud volumes are rarely needed as animals hear much better than we do.
Battery/Charging Recommendations
•
Remember that NiMH batteries self-discharge about 1% per day
•
Do not leave charging batteries unattended
•
Remove batteries from battery holder when caller will not be used for
prolonged periods to help prevent deep discharge
•
Recharge your batteries periodically—even when not in use—to
prevent deep discharge
4.0 “AUX” JACK FUNCTION
The FURY 2 is equipped with an auxiliary jack labeled “AUX”. The purpose of
this jack is to allow for the connection of certain external devices, such as the
FOXPRO
®
Jack-in-the-Box Decoy or other approved devices, and to be able to
turn these on and off with the TX-505 remote control transmitter. However,
there are some strict electrical limits involved with this jack. If these limits are
exceeded, damage to your FURY 2 will result. This damage is not covered by
warranty.
The electrically inclined will want to know that the jack is connected to the drain
of an internal Field Effect Transistor with a maximum current rating of 2
Amperes. The “tip” polarity of the 3.5mm jack is positive, while the sleeve is
negative. If the external device is connected with the polarity reversed, an
internal protection diode within the FET will conduct, causing the device to stay