Foxpro FURY 2, Инструкция по эксплуатации

Страница: 23 / 36

23 | P a g e
3) Highlight the AUX menu item and press the rotary selector knob one
time.
4) Highlight the desired operation, either MOMENTARY or LATCHED
menu item and press the rotary selector knob one time.
5) Exit the menu.
Note: For use with the FOXPRO
®
Jack-in-the-Box Decoy, make sure you
select MOMENTARY.
6.12 RECALL
The recall button will allow the last previous sound and volume setting to be
recalled and played. For example, let’s say you just switched your sound from
a rabbit distress at volume 18 to a coyote pup distress. Now, you bring the
volume up on that coyote pup distress to volume 29. By depressing the recall
button, your sound will switch from the coyote pup distress at volume 29, back
to the rabbit distress at volume 18. The recall button will also work with the
presets.
NOTE: If you press the recall button while playing a sequence, you
will go back to the last sound and volume level that was used prior to
entering sequence mode.
6.13 CHANNEL SELECTION
The TX-505 has been designed to be able to operate up to 16 different
FOXPRO
®
FURY 2 units. This is great for folks who are using multiple units
and wish to control them from a single transmitter. It is also convenient for folks
who are hunting with a partner who is also using a FURY 2 so you can both
operate on separate channels without interfering with one another.
You can quickly and easily change the channel of operation through the menu,
but you must be certain that your FURY 2 and TX-505 are both set to operate
on the same channel.
Changing the Channel of Operation on the TX-505
1) Access the main menu by pressing and holding the rotary selector
knob for about 2-3 seconds
2) Highlight the TX505 CONFIG menu item and press down on the rotary
selector knob one time
3) Highlight the CHANNEL menu item and press down on the rotary
selector knob one time
4) Rotate the rotary selector knob clockwise or counterclockwise to
increment/decrement through the available channels. When you arrive
on the desired channel, press down on the rotary selector knob