Foxpro FURY 2, Инструкция по эксплуатации

Страница: 8 / 36

8 | P a g e
run time of these batteries can be very short. The Zinc Carbon so-called
“Heavy Duty” cells are expressly NOT recommended at all.
The performance of your FURY 2 will be much better with high capacity
NiMH batteries
.
3.1 INSTALLING BATTERIES IN THE FURY 2:
1) Remove the battery door. The battery door is located on the side of
the caller and is held in place with a knurled thumbscrew
.
2) Orient the batteries as per the directions shown in each cavity within
the holder.
Note that the battery polarity alternates
.
3) Replace the battery door after the batteries are installed.
CAUTION: Never attempt to charge batteries not intended to be
recharged!
This includes both Zinc Carbon and alkaline cells. The resulting
damage can be serious and will not be covered by the warranty. For maximum
charge efficiency, we recommend charging your FURY 2 in temperatures
ranging from 40°F to 85°F (5°C to 30°C).
CAUTION: Do not mix battery types!
CAUTION: Never connect your FURY 2 to an unregulated 12V system (i.e.
automotive systems, high current power supplies, etc.)
Serious damage
will occur which is not covered by the warranty. The charge jack is intended
only for FOXPRO
®
chargers.
CAUTION: Never attach an unapproved or non-FOXPRO
®
charger to your
FURY 2!
Damages caused be plugging unapproved charging devices into your
FURY 2 will not be covered by warranty.
3.2 CHARGING BATTERIES
1) Disconnect any accessory device(s) that may be attached to the FURY
2 prior to charging. This includes external speakers, USB cables, and
any devices that may be attached to the auxiliary device jack.
2) Check to make sure that rechargeable NiMH type batteries are
installed in your FURY 2.
3) Connect the approved FOXPRO
®
charger to the FURY 2 charge jack
and attach the transformer end of the charger to the appropriate outlet.
Be aware that the green LED may or may not extinguish when the
batteries are fully charged.
Your FOXPRO
®
unit incorporates circuitry to terminate charge current if high
battery temperatures are detected. Battery temperatures increase at the end of