FoxGate S63 series, Руководство по настройке

Страница: 40 / 565

Basic Switch Configuration
39
ssh-server timeout <timeout>
no ssh-server timeout
Configure timeout value for SSH
authentication; the no command restores
the default timeout value for SSH
authentication.
ssh-server authentication-retires
<authentication-retires>
no ssh-server authentication-retries
Configure the number of times for retrying
SSH authentication; the no command
restores the default number of times for
retrying SSH authentication.
ssh-server host-key create rsa
modulus <moduls>
Generate the new RSA host key on the
SSH server.
Admin Mode
terminal monitor
terminal no monitor
Display SSH debug information on the
SSH client side; the no command stops
displaying SSH debug information on the
SSH client side.
2.2.2.3
Example of SSH Server Configuration
Example1:
Requirement: Enable SSH server on the switch, and run SSH2.0 client software such
as Secure shell client or putty on the terminal. Log on the switch by using the username
and password from the client.
Configure the IP address, add SSH user and enable SSH service on the switch.
SSH2.0 client can log on the switch by using the username and password to configure the
switch.
Switch(config)#ssh-server enable
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip address 100.100.100.200 255.255.255.0
Switch(Config-if-Vlan1)#exit
Switch(config)#username test privilege 15 password 0 test
In IPv6 networks, the terminal should run SSH client software which support IPv6,
such as putty6. Users should not modify the configuration of the switch except allocating
an IPv6 address for the local host.
2.3
Configure Switch IP Addresses
All Ethernet ports of switch are default to Data Link layer ports and perform layer 2
forwarding. VLAN interface represent a Layer 3 interface function which can be assigned