FoxGate S63 series, Руководство по настройке

Страница: 177 / 565

MAC Table Configuration
176
Admin Mode
clear port-security dynamic [address
< mac-addr> | interface < interface-id> ]
Clear dynamic MAC addresses learned
by the specified port.
3. MAC address binding property configuration
Command Explanation
Port Mode
switchport port-security maximum
< value>
no switchport port-security maximum
< value>
Set the maximum number of secure
MAC
addresses for a port; the ―
no
switchport port-security maximum
‖
command restores the default value.
switchport port-security violation
{protect | shutdown} [recovery
<30-3600>]
no switchport port-security violation
Set the violation mode for the port; the
―
no switchport port-security violation
‖
command restores the default setting.
4. mac-notification trap configuration
Command Explanation
Global Mode
mac-address-table
periodic-monitor-time <5-86400>
Set the MAC monitor interval to count the
added and deleted MAC in time, and
send out them with trap message.
18.5.1.3
Binding MAC Address Binding Troubleshooting
Enabling MAC address binding for ports may fail in some occasions. Here are some
possible causes and solutions:

If MAC address binding cannot be enabled for a port, make sure the port is not
enabling port aggregation and is not configured as a Trunk port. MAC address binding
is exclusive to such configurations. If MAC address binding is to be enabled, the
functions mentioned above must be disabled first.

If a secure address is set as static address and deleted, that secure address will be
unusable even though it exists. For this reason, it is recommended to avoid static
address for ports enabling MAC address.