FoxGate S6124, Руководство по управлению

Страница: 69 / 391

69
Switch#cluster reset member 1
2.10 cluster run
Command: cluster run [key <WORD> ] [ vid <VID> ]
no cluster run
Function:
Enable cluster function; the ―
no cluster run
‖ command disables cluster
function.
Parameter: key
：
all keys in one cluster should be the same, no longer than 16 characters.
vid
：
vlan id of the cluster, whose range is 1-4094.
Command mode: Global Mode
Default: Cluster function is disabled by default, key: NULL(\0) vid
：
1.
Instructions: This command enables cluster function. Cluster function has to be enabled
before implementing any other cluster commands. The ―
no cluster run
‖ disables cluster
function. It is recommended that users allocate an exclusive vlan for cluster
（
such as
vlan100
）
Note
：
Routing protocols should be disabled on the layer-3 interface where cluster vlan
locates to avoid broadcasting private route of the cluster.
Example: Disable cluster function in the local switch.
Switch (config)#no cluster run
2.11 cluster update member
Command: cluster update member <member-id> <src-url> <dst-filename> [ascii |
binary]
Function: Remotely upgrade member switches from the commander switch.
Parameters: member-id
：
ranging from 1 to 128. Use hyphen
―-‖ or semicolon ―
；
‖ to specify
more than one member;
src-url
：
the location of source files to be copied;
dst-filename
：
the specified filename for saving the file in the switch flash;
ascii means that the file transmission follows ASCII standard; binary means that the
file transmission follows binary standard, which is de default mode.
when src-url is a FTP address, its form will be:
ftp://<username>:<password>@<ipadress>/<filename>
，
in which <username> is the
FTP username <password> is the FTP password <ipadress> is the IP address of the FTP
server,<filename> is the name of the file to be downloaded via FTP.
when src-url is a TFTP address, its form will be: tftp://<ipadress>/<filename>
，
in which