Fostex VF-160, Руководство по эксплуатации

Страница: 124 / 154

124
6. If you agree to the message contents, press the [ENTER/
YES] key.
After showing “
Set Enable!
”, the display shows the screen
for selecting the song(s) to be loaded.
If there is more than one track recorded on the audio CD,
“ ” flashes, showing that you can select a desired track.
If there is only one track recorded on the audio CD, “ ”
is not shown on the screen.
7. Use the [JOG] dial to select a track number to be loaded and
press the [ENTER/YES] key.
The destination program number starts flashing, which is
one greater than the highest program number among those
available on the current drive. This means a track is going
to be loaded to a new program.
For example, if there are 4 programs available on the current
drive, the destination program number is
"P05"
.
If there are already 99 programs on the current drive,
"Disk
Full!"
appears and no destination program number is shown.
In such a case, delete the unnecessary program(s) on the
current drive and then perform step 7 above again.
<Hint>
If you are going to load tracks 1 and 3 in the example
above, instead of tracks 1 and 2, track 3 will be loaded
to program 06 (see the screen example below).
However, if you select track 2 after selecting tracks 1
and 3, the unit automatically reassigns track 2 to pro-
gram 06 and track 3 to program 07 (see the screen
example below).
9. After specifying track(s) to be loaded, press the
[ENTER/YES] key while holding down the [RECORD] key.
The VF160 starts loading tracks to the current drive.
The following screen example shows that track 1 is now
being loaded to program 08 on the current drive.
10. Press the [EXIT/NO] key to quit the Setup mode.
The display returns to the Normal display that was shown
last time before entering the Setup mode.
<When only one track is recorded>
<When more than one track is recorded>
<Note>
When loading from an audio CD, no title is shown when
selecting the track.
8. While the program number is flashing, press the [ENTER/
YES] key.
The flashing program number changes to light solidly,
showing that the first track is ready to be loaded to the
program.
F l a s h i n g
By rotating the
[JOG]
dial, you can select
"NON"
, as well as
a
"Program"
. When performing the load operation, tracks
that are set to
"NON"
are not loaded.
To load more than one track, repeat steps 7 through 8
above.
The following screen example shows that tracks 1 and 2
will be loaded to program 05 and 06 respectively.
The track title and track time are also shown to the left
of each program number.
When the loading ends, “
Load Completed!
” appears on the
screen, while the disc is automatically ejected from the
CD-RW drive.