Fostex VF-160, Руководство по эксплуатации

Страница: 82 / 154

82
<Hint>
However, if you make an audio CD from the material whose actual audio starts from the exact “
CLIPBOARD IN
point
”, there will be no silence before starting audio.
If you want to make a CD which have a silence before actual audio starts, move back the mixed-down data for
a few seconds as shown in
Figure-2
, or move ahead the “
CLIPBOARD IN point
” for a few seconds as shown in
Figure-3
.
When internal mixdown is completed, the starting and editing times of the mixdown are registered as “
CLIP-
BOARD IN point
” and “
CLIPBOARD OUT point
” respectively (see the illustrations below).
This is because, when making an audio CD from the mixed-down material, data between “
CLIPBOARD IN point
”
and “
CLIPBOARD OUT point
” is automatically recorded.
Regardless of the starting point of mixdown, only the data between “
CLIPBOARD IN point
” and “
CLIPBOARD OUT
point
” is recorded when making an audio CD. In other words, you cannot make an audio CD without setting
these two points.
When internal mixdown starts from “ABS 0” and ends at
“ABS 05M 00S 00F”.
When internal mixdown starts from “ABS 00M 10S 00F”
and at “ABS 06M 00S 00F”.
ABS 0
ABS 05M 00S 00F
mixed-down song data
CLIPBOARD OUT point
CLIPBOARD IN point
ABS 00M 10S 00F
ABS 06M 00S 00F
CLIPBOARD OUT point
CLIPBOARD IN point
ABS 0
mixed-down song data
<Figure-1>
ABS 0
REC END
CLIPBOARD OUT point
CLIPBOARD IN point
ABS 0
REC END
silent
mixed-down song data
mixed-down song data
Move & Paste
ABS 0
REC END
CLIPBOARD OUT point
CLIPBOARD IN point
REC END
CLIPBOARD IN point
CLIPBOARD OUT point
mixed-down song data
mixed-down song data
<Note>
When you move data as shown in
Figure-2
, the
“
CLIPBOARD IN point
” is not changed, while the
“
CLIPBOARD OUT point
” moves (as shown in
Fig-
ure-4
).
If you record data to a CD-RW or CD-R disc with-
out changing the CLIPBOARD OUT point, data
between the CLIPBOARD IN and OUT points is
recorded but data between the CLIPBOARD OUT
and REC END points are not recorded.
Therefore, you have to set the “
CLIPBOARD OUT
point
” to the same point as the “
REC END point
” or
latter point.
When recording songs continuously to a CD-RW/CD-R disc, the unit automatically record a 2-second
silence after the “
REC END point
”. Therefore, you do not have to make a silence as shown above if a 2-
second silence is enough for you. If you want to have a longer silence than 2 seconds, use either of two
methods shown above to make a silence longer. See the next page for details about how to make a silence.
<Note>
ABS 0
REC END
mixed-down song data
CLIPBOARD OUT point
CLIPBOARD IN point
ABS 0
REC END
CLIPBOARD IN point
mixed-down song data
<Figure-3>
<Figure-2>
<Figure-4>