Fostex VF-160, Руководство по эксплуатации

Страница: 121 / 154

121
To change the setting, press the
[ENTER/YES]
key when
the “
CD-DA Setup
” screen is shown. The current setting
starts flashing, showing it can be edited.
While flashing, use the
[JOG]
dial to select “
ON
” or “
OFF
”,
then press the
[ENTER/YES]
key to confirm.
Copy protection setting
You can restrict the disc copy (duplication) ca-
pability of an audio CD you are going to make.
7. While “CD-DA” is flashing, press the [ENTER/YES] key.
After showing “
Please Wait!
”, the display shows the screen
for selecting the program(s) to be record.
In the screen, a number such as “
01
” or “
02
” shows the
track number, while “
NON
” shows that no program is
assigned to the track.
8. Press the [ENTER/YES] key again.
The highest program number available on the current
drive starts flashing and its program title and the
recording time are also shown. At the top of the program
table, the total time of the program is shown.
9. Use the [JOG] dial to select a desired program and press
the [ENTER/YES] key.
The selected program is set to the first track.
<Note>
If the program time shows “
00: 00”
when selecting a
program as the screen example below, the CLIPBOARD
IN and CLIPBOARD OUT points are not correctly set.
6. After setting the copy protection, press the [EXIT/NO] key.
The display returns to the screen for selecting the save
mode, in which “
CD-DA
” now flashes.
Flashing
Flashing
Flashing
“ON” A disc you made can be copied to other digital
device once.
“OFF” A disc you made can be copied to other digital
device as many times as required (default).
• To record a single song to a CD-RW/CD-R disc, select
a program and press the
[ENTER/YES]
key, and then
go to step 10.
• To record more than one song to a CD-RW/CD-R disc,
repeat the procedure for selecting a program
described above (i.e. use the
[JOG]
dial to select a
program and press the
[ENTER/YES]
key) until
selecting all desired programs, and then go to step
10.
If you press the
[ENTER/YES]
key after selecting such
a program, the warning message as below appears
on the display and you cannot select the program.
“Void In!”, “Void Out!”, or “Void Data!”
It is possible to select a program that is not mixed
down if it holds the correct “IN” and “OUT” points.
However, if you record such a program to a CD-RW/
CD-R disc with the audio CD format, only track 1
and 2 can be recorded.
So, make sure that you select programs properly
when making an audio CD.
In other words, in the following conditions, the
CLIPBOARD IN and CLIPBOARD OUT points are
not regarded as being correctly set.
CLIPBOARD IN point = CLIPBOARD OUT point
CLIPBOARD IN point > CLIPBOARD OUT point
Flashing