FORTEZA JSC FORTEZA FMC 24 Pro (100m, 200m, 300m)
Please visit our internet sites:
6.3.1.
Do these passages in “full height” and “bent” on different distances from Tx and
Rx. It is recommended to begin doing these “approved” passages in the middle of the
protected zone. After each passage it is necessary to leave the detection zone for the distance
of 1-2 m and make a pause from 5 to 7 sec. Otherwise, the results of the previous passage
can influence on the next one.
Fig. 6.3
6.3.2.
You can change the minimum detected speed in m/s (Vmin), the maximum
detected speed in m/s (Vmax). You can confirm your settings with ‘Apply’ button.
Note: Too big speed range has higher false alarm rate, too low speed range has poor
sensitivity.
6.3.3. Setup method: Manual
In ‘Manual’ setup method you can set sensitivity. But in most of the case ‘Auto’ mode
and default sensitivity value is recommended. You can send your setting to the receiver with
‘Apply’ button, or you can cancel your settings with ‘Cancel’ button.
Note: Black line – signal between transmitter and receiver
Green and Blue – 1 section alarm thresholds
Red – 2 section alarm threshold (Alarm)
