FORTEZA JSC FORTEZA FMC 24 Pro (100m, 200m, 300m)
Please visit our internet sites:
2.4. Sensor adjustment with the built-in adjustment, control and indication parts
2.4.1 Preliminary adjustment of Tx and Rx
2.4.1.1. Loosen the screws securing the receiver and transmitter bracket (Fig.1.2).
2.4.1.2. Point the receiver and transmitter at each other.
2.4.1.3. Tighten the bracket mounting bolts.
2.4.2. Main adjustment of Tx and Rx
2.4.2.1. Open the receivers/transmitters cover (fig.1.2).
2.4.2.2 Channel tuning. The receiver and transmitter must operate on the same
channel. For other near detection zones other channels must be set.
2.4.2.3 Check the sensors connections between power supply circuit and output
circuit.
Turn on the power supply.
2.4.2.4. When power is supplied to the sensor units (receiver and transmitter), a
flashing LED informs about the set channel.
TRANSMITTER. After supplying power LED will blink as many times as the set
channel is set, then it will light continuously, which means that the power supply is correct
and the transmitter is operating normally.
If the LED blinks in red, it means that the power supply current is below the required
value of 9V;
A rare blinking of the red LED indicates a transmitter malfunction.
RECEIVER. After supplying power, the LED will flash as many times as the set channel is
set, after that it will start to light in green, what means that:
- power is supplied
- synchronization of the receiver with the transmitter happened.
- the signal level is within the appropriate range.
- the protection zone is secured.
Red LED light means that the sensor is in the “alarm trigger" state because:
- no signal is received from the transmitter;
- the received signal is too strong;
- intrusion into the protection zone;
If the LED flashes in red, it means that the supply current is below the required values
of 9V;
A rare blinking of red indicates that the signal level is in the wrong range.
- Continuous red light with periodic LED going off (1 time every 4 seconds) means
that the level of the received signal exceeds the permissible level (> 650 mV).
- Flashing red LED indicates that an ANDROID or WINDOWS device is connected
to the receiver and compatibility is in progress.
