7.3.2 Indications (diagnostics) of the safety curtain after switching on the
power supply.
When the cutter is switched on, the transmitter 1 and receiver 2 are initialized
(fig. 16). All transmitter and receiver LEDs will light for a moment. After initialization the
receiver indicates the quality of the setting using four blue LEDs 3 (Fig.11). Table 8.
The setting indicator extinguishes after a suitable time when the safety light curtain is
set (the LED of the device switching the output signal: green item 1 figure 11) and only
the PWR LED of transmitter 1 (fig.12) and LED 1 (fig. 11) device for switching the
receiver's output signal. In the event of an error on the device, the red LED will light. On
the side receiver red error LED - in combination with blue LEDs - indicates the cause of
the error.
Danger!
In case of malfunction of photocells, immediately contact the service!
7.3.3 Emergency stop of the cutter
1. Press the button 5 (Fig. 15)
The switch is used for emergency stopping of the machine.
After pressing it, the message "Disable safety button" will appear on the programmer.
The pressure bar and knife will stop.
7.3.4 Starting the cutter after emergency stop
1. Unlock button 5 (turn it around) (Fig.15)
2. Press the green 2 "I" button
When the stop has been made during the cutting cycle, pressing the cutting buttons
again will result in returning to the upper position of the clamping beam and the knife
7.4 Determining the position of the approaching beam
Danger!
Do not put your hands into the cutting area when backgauge moves!
Содержание Cut-True 31H
