7.5.2 Changing the clamping force
The change of clamping force can be done by manual crank rotation 3 and
reading the value of pressure on manometer 4 (fig. 18)
turning right - clamp pressure increase
turning left- clamp pressure decrease
Approximate values of the clamping force depending on the pressure value
read on the pressure gauge (manometer) 4
25 bar ~ 300 daN
40 bar ~ 650 daN
55 bar ~ 1000 daN
70 bar ~ 1350 daN
90 bar ~ 1700 daN
110 bar ~ 2000 daN
7.5.3 Rules for selecting the clamping force.
The value of the pressing force is selected experimentally, in relation to the
type, width and height of the cut material.
The following rules must be observed:
• the higher the pile, the greater the downforce
• the greater the cutting width, the greater the downforce
• the harder the material, the greater the downforce
7.6 Cutting line indicator (optical)
The cutter is equipped with an optical cutting line indicator. A thin light line
indicates the cutting line on the material to be cut.
7.7 Cutting (clamping and cutting)
Danger!
Do not put hands into cutting zone!
Содержание Cut-True 31H
