1 (2)
Operation using LK Heat Cutter 90 W
Ensure working areas are well ventilated and
wear a protective mask; the fumes that are crea-
ted can be health hazardous.
Do not cut PVC and PVC-coated materials, the
toxic fumes are hazardous. Take care when using
the tool to prevent accidental burns and fires.
The blade may reach 600°C / 1100°F. Never touch
the blade when the power switch is pushed. Do
not place the tool against any surface after usage
until the blades have cooled down. Do not use
the product in unsuitable environments.
Unsuitable environments are:
• Wet areas or in high air humidity.
• Dust and flammable gases, fumes or sol-
vents.
• Strong vibrations.
Always unplug the device when not in use.
Design
LK Heat Cutter 90 W is an electric heated tool for
cutting pipe grooves in LK Slotted Board and LK
Turning Board EPS 30/50/70. The heat cutter can
be supplemented with additional groove blades
and/or knife blades. The tool works by heating
the groove blade to melt/carve pipe grooves in
EPS-Styrofoam insulation boards.
LK Groove blades are available in dimensions
16, 25 and 32-34. The size range accommodates
16mm pipe and two sizes of conduit.
LK Knife Blade 40 is available as an accessory
for cutting EPS boards up to 50 mm. As the bla-
de cannot cut through thicknesses over 40 mm,
an initial straight cut is made, the board is then
snapped off.
LK Knife Blade and LK Groove Blade.
LK Turning template EPS
To facilitate tracking at turning pipes, LK Turning
template EPS is avaliable. See accessories.
LK Heat Cutter 90 W
EN.33.C.125.1606
Assembly instructions | LK Heat Cutter 90 W
