Fore Systems ES-2810, Руководство пользователя

Страница: 19 / 60

ES-2810 ATM Uplink Module User Guide 2 - 5
Installation
2.5.2 Stack Mode Cabling
Once the ATM Module is installed, use the following procedure to connect the
ATM Module in a stack configuration to an ATM switch:
NOTE
Depending on the number of switches in a
stack, up to two ATM Modules can be
supported. The ATM Module should only be
installed in slot A of an ES-2810 switch.
1. Connect the ATM Module to the Matrix Module as follows:
a. Connect the SIM connector on the ATM Module to one of the ports
on the Matrix Module.
b. Connect the ATM-Stack connector on the ATM Module to another
port on the Matrix Module.
2. Connect the ATM port on the ATM Module to an ATM switch on the
ATM network. The finished cabling should look similar to the
following:
Figure 6 - Stack Mode Cabling (2-switch stack)
3. Check the LEDs on the module to verify the ATM link:
- All LEDs should illuminate green.
- Appropriate TX or RX LEDs (depending on whether you are
transmitting or receiving cells to/from the ATM network) for
the ATM port should illuminate green.
4. If you want to install a second ATM Module in slot A of another switch
in the stack, repeat steps 1 through 3.
NOTE
If there are other switches in the stack, make
sure the Stack Interface Module on the other
switches connect to the Matrix Module.
ATM-Stack
connected
to a port
on the
Matrix
Module
SIM connected to a port
on the Matrix Module
155 Mbps connection
to ATM ELAN