Fore Systems ES-2810, Руководство пользователя

Страница: 18 / 60

2 - 4 ES-2810 ATM Uplink Module User Guide
Installation
2.4 Removing an ATM Module
Use the following procedure to remove an ATM Module from your ES-2810:
WARNING! Modules are not designed to be installed in,
or removed from the switch while in
operation. You must power off the switch
before installing/removing a module.
1. Turn off the switch and remove the cables.
2. Unscrew the retaining screws to release the module from the switch.
3. Gently pull the module by the retaining screws to disengage the con-
nectors fully from the socket on the motherboard. Slide the module out
of the slot completely.
4. If you are not replacing the slot with another module, cover the empty
module slot with the plate and secure using the screws.
2.5 Cabling
The cable connections to the ATM Module depend on the operating mode in which
the module is to be used: stand-alone or stack.
2.5.1 Stand-Alone Mode Cabling
Once the ATM Module has been installed, use the following procedure to connect
the ATM Module in a single ES-2810 to an ATM switch:
1. Connect the ATM port on the ATM Module to an ATM switch on the
ATM ELAN. The cabling should look like the following:
Figure 5 -
Stand-Alone Mode Cabling
2. Check the LEDs on the module to verify the ATM link:
- CPU LED should illuminate green and all other LEDs should
be off.
- Appropriate TX or RX LEDs (depending on whether you are
transmitting or receiving cells to/from the ATM network) for
the ATM port should illuminate green.
3. Once the module is installed and properly cabled, you can configure
the module using FORE Stack View. See Chapter 4.
To ATM Switch
ATM Port