14
4.3.3
UHF channel (Start-up > TV-format)
This enables you to select the channel used on the RF Output to carry the decoded channel.
If you are not using the RF Output from the receiver, ignore this step.
If you are using the RF Output, find out if channel 36 is already used. If it is not, then use this default value. If channel
36 is already in use, select a free analogue channel in the range 21 to 65.
Highlight the item, press OK and select the required channel in the list.
4.3.4
RF System
Here you can select the version of PAL that your TV uses.
When you have completed making your selections on this page, highlight SUMBIT and press OK.
4.3.5
Active Antenna
If you have an active antenna on your terrestrial receiver, 5 Volt, otherwise leave it at 0 Volt.
4.4
Positions (Start-up)
In this item you select how many satellites your dish is to have access to, see Figure 14 (Positions).
A typical Nordic system with 2 LNB heads will use Thor and Sirius. Highlight positions with the arrow buttons and press
OK to select. Press OK again to deselect. The satellites selected are those with an X in the box against the name.
If the satellites from which you want to receive are not shown here, they can be selected later and searched for
available channels, see section 8.2.2.
Figure 14
(Positions)
The installation wizard sets up the basic parameters for the LNB, but advanced settings are configured after the wizard
has finished. These are described in section 4.7.
4.5
Channel search (Start-up)
If you have a terrestrial receiver, it will now search for all the available TV and radio channels. This may take a few
minutes, but you will see the UHF channel number increase and a yellow bar to show progress; all the channels up to 69
are checked in turn.
If you have connected the receiver correctly, the list of available channels will be shown at the right of your TV screen.
The order of channels in the channel list is determined by the frequency on which they are transmitted. If for any reason
you are unable to receive a signal at this stage and therefore the channel search does not work, complete the set-up
process and then investigate using the on-screen menus.
Once the search is complete, you will see a message “Press OK to continue." Use your remote control to do this.
If a programme card is required for reception, you should now place it in card reader A or B, with the components on
the lower surface and the contact surface downwards.
NOTE:
On start-up, you may get the error message "no access". The programme card needs to be updated with your user
privileges. This will take approximately 20 minutes. Switch the receiver on and leave the card in until it is updated.
English
