Foma D704i, Руководство пользователя, Страница: 38 / 498

36 Before Using the Handset
INFORMATION
●
The FOMA terminal display uses an active LCD. Due to the characteristics of active LCD, residual images or crossbar may
remain for a while when the battery pack is attached or removed. This is not a fault of the FOMA terminal.
●
When you remove the battery pack, reservation of software update may be canceled. If you set
Auto time adjust
to
OFF
and enter the date and time manually in Date and Time Setting, the set date and time may be cleared when you remove
the battery pack.
●
When you remove the battery pack, i-
α
ppli which uses the date and time information set on the standby display may not
run correctly. In that case, set the date and time again.
Charging the FOMA terminal
When the battery level is low, charge the battery.
･
The battery level icon shows how much charge remains in the battery.
☛
P39
Battery pack life
■
The battery pack is a consumable part
Each time it is charged, it will accept slightly less charge than the previous time.
■ When the battery charge lasts only half as long as when it was new
The end of battery pack life is approaching. Replace it with a new one immediately. Depending on usage, the
battery pack may swell as it nears the end of its life, but this will not cause a problem.
■
If you use i-
α
ppli, videophone or 1Seg for a long time during charging
The battery pack life may be shortened.
■ The FOMA terminal uses a lithium ion battery containing valuable materials that
should be recycled
To protect the environment, return used batteries to an NTT DoCoMo service counter, NTT
DoCoMo agent or recycling center.
■
Take the following precautions when recycling batteries
･
Attach a piece of adhesive tape on the terminals of used battery packs.
･
Do not disassemble or modify battery packs.
d
Place the back cover plate so that it can slide
about 2 mm on the FOMA terminal.
e
Slide the back cover in the direction of the arrow
while pushing its center with your thumb so that
the FOMA terminal and the back cover do not gap.
Failure to follow the correct procedure could damage the
back cover.
Removing the battery pack
a
Remove the back cover.
b
Lift the projection of the battery pack using your
finger and remove it.
Projection
Li-ion