FOM INDUSTRIE BLITZ, Руководство по эксплуатации и обслуживанию

Страница: 83 / 152

77
BLITZ
G B G B
G B G B
G B
10-17
A
C
D
E
B
Internal vertical vice ( Fig. 10-17 )
1 ) Turn the master switch to “0” and secure it with a padlock, then turn the main switch (400 V - three-phase)
to “0” .
2) Remove the PVC pad.
3) Disconnect tube “A” .
4) Undo grub screw “B” and screw “C” of the reed in order to remove the reed and its cylindrical support.
5) Undo release handle “D” and take out cylinder “E” .
6) Remove ring “F” from the old cylinder by undoing the grub screw and fit it to the new cylinder making sure
it goes in exactly the same position as before (see measurement in the figure).
7) Replace the cylinder in its housing and tighten release handle “A” .
8) Refit the PVC pad (or fit a new one if necessary).
9) Fix the reed (making sure the position of the cylindrical support is perfectly level with the cylinder) tightening
grub screw
“B” and screw “C” .
10) Connect up tube “A” .
11) Release the pneumatic master switch and turn it to “I” then turn the main switch to “I” .
12) Carry out a few test runs (e.g. to check the reed is on with the vice raised).
F
90 mm.