FOM INDUSTRIE BLITZ, Руководство по эксплуатации и обслуживанию

Страница: 79 / 152

73
BLITZ
G B G B
G B G B
G B
10-12
B
10.6 FITTING A NEW REMOTE CONTROL SWITCH
If the motor does not start, even though power is being supplied to the machine and the compressed air
connection has been made properly, it means that the remote control switch is faulty, and so it needs to be
replaced by the following procedure:
1 ) Turn the pneumatic master switch to “0” a nd secure it with a padlock. Then open the main switch and
secure that too with a padlock.
2 ) Open the door of the electrical cabinet “A” - Fig. 10-11 using the triangular spanner supplied.
3 ) Using a screwdriver as a lever, prise the remote control switch “B” - Fig. 10-12 from the omega bar which
it is fixed to.
4 ) Disconnect the auxiliary connections fixed to the sides of the remote control switch, undoing the two
corresponding screws without having to disconnect the electrical wires from these contacts.
5 ) Disconnect the wires from the old remote control switch and connect them to the new one being careful
to attach the wires in the same point.
6 ) Hook up the auxiliary contacts again with the relative screws.
7 ) Fix the remote control switch to the omega bar again
8 ) Close the door of the electrical cabinet “A” - Fig. 10-11 .
9 ) Release the pneumatic master switch and set it to “I” , remove the padlock from the main switch, then
restore power to the machine using the same switch.
10 ) Carry out a few test runs.
10-11
A