FOM INDUSTRIE BLITZ, Руководство по эксплуатации и обслуживанию

Страница: 47 / 152

41
BLITZ
G B G B
G B G B
G B
8 PROCEDURE FOR START UP AND MACHINING
- Turn the main power switch to position “I”.
WARNING
The machine is now being supplied with electrical power
- Enable the machine for work by pressing button
“1” - Fig. 06-02 located on the control console .
WARNING
Before carrying out any operations, check the direction of rotation of the blades by starting one of the 2 motors
(see attached software manual). Immediately after, press the emergency stop button to stop the motor. The
direction of rotation of the blade can be seen through the front blade exit slot.
If the blades are seen to rotate in the opposite direction, then two of the three electrical power phases of the
BLITZ
must be inverted.
N.B
: The correct direction of blade rotation can be seen from the plate with an arrow
“1” - Fig. 02-02
affixed
to the head guards.
After enabling the machine, carry out the zeroing procedure (see attached software manual); this must be done
every time the machine is switched on or when the mobile head position has been changed by a non electrical
means.
Start the fixed head and mobile head blade motors by pressing the F1 and F5 buttons
MANUAL CUTTING
Turn selector “1” - Fig. 06-03 (where present) to activate the ‘MANUAL’ cutting mode.
Set the required cutting measurements on the equipment (see the enclosed manual).
Position the profile on the worktable and clamp it in place with the vices by pressing button
“2” - Fig. 06-02 .
WARNING
When handling any profile the wearing of safety gloves is mandatory.
IMPORTANT
In this condition of the machine being enabled for work, the vices clamp the profile in “low pressure” (~ 0.8 bar
working pressure) to allow positioning and to avoid fingers or hands being crushed.
However, if any re-positioning is needed to clamp the profile perfectly, press again the open vices button
“2”
- Fig. 06-02 , then follow the indications given in Paragraphs. 9.1 and 9.2.
By pressing together (and keeping pressed down) the cutting buttons “3” - Fig. 06-02 the hoods are closed
and, once the hoods are completely closed, the blades come out to cut.
IMPORTANT
Before the sawblade comes out to cut, the vices clamp the profile on the worktable in high pressure.
Under normal conditions of use, after making the cut, the blade goes back in immediately, the mobile safety
hoods will raise, the vices open automatically to allow the cut profile to be removed and another profile to be
put in position for cutting.