Operating Manual CMGZ411/421
33
Integral component I
Purpose:
The time stored here is responsible for the integral component. It is stored independently of
proportional or derivative component.
Range:
0.01 to
100.00
Default:
1.00
Increment:
0.01
Unit:
[s]
Derivative component D
Purpose:
The time entered under this parameter is responsible for the derivative component. It is stored
independently of proportional or integral component.The derivative component is only active if
the respective configuration of the controller is chosen under Parameter „PID configuration“.
Range:
0.001 to
10.000
Default:
0.010
Increment:
0.001
Unit:
[s]
Alarm controller error
Purpose:
If the control error is higher than the value stored in this parameter, this is indicated by a digital
output and the answer to the referring interface command.
The value means the percentage quota of the nominal force of the sensors.
Range:
0.1
to
100.0
Default:
10.0
Increment:
0.1
Unit:
[%]
Machine configuration
Purpose:
The machine configuration depends on the arrangement as winder/unwinder, intermediat drive or
brake to get correct feedback signal for all of these conditions.
The selection is easy with the illustrations in chapter 7.
Range:
1
to
23
Default:
1
Increment:
1
Unit:
[-]
Output configuration
Purpose:
This parameter allows to select a appropriate output signal depending on the application.
Range:
0...10V, ±10V, 0.0.20mA, 4..20mA
Start speed
Purpose:
If there is slack material in the machine when the controller is enabled, the drive would take up the
slack very fast. If tension is reached, the drive cannot decelerate fast enough, so that material
cracking can be the result. To avoid this, the controller drives with a low speed given with this
parameter until a certain tension (Parameter Start limit) is reached.
If a brake is controlled, the controller starts from the torque stored here and reduces after disabling
again to this torque.
Range:
0.00 to
50.00
Default:
0.00
Increment:
0.01
Unit:
[% max. output signal]
Содержание CMGZ411
